BEFORE FIRST USE
1. Remove all packaging.
2. Check to be sure you have all the following parts:
- 4 removable Wine Racks - Gently slide the racks into the Wine Cellar.
- 1 Air Filter - If not already in place, slide the Air Inlet filter into the guides
on the back of the Wine Cellar.
Installation
1. Place the Wine Cellar on a flat level surface that is strong enough to
support it when fully loaded. If needed, adjust the leveling feet under the
unit so that the appliance sits perfectly level. The Wine Cellar will fit on a
kitchen countertop under cabinets that have a minimum clearance of 18”
(45 cm).
2. The Wine Cellar is designed for indoor use only. The thermoelectric cooling
system operates efficiently in an ambient temperature up to 25°C (77°F).
3. Allow 5” (13 cm) of space at the rear and both sides of the Wine Cellar to
allow for proper ventilation.
4. DO NOT place next to any appliance that emits a large amount of heat,
such as a dishwasher, oven, microwave, toaster, etc. or in direct sunlight.
IMPORTANT NOTE: This Wine Cellar is intended to be used indoors. It is
designed to maintain an interior temperature that is, at most, 18°C (32°F)
lower than the temperature of the room in which it is situated. Therefore, if
the ambient temperature is higher than 25°C (77°F) the Wine Cellar might
not be able to maintain the lowest interior temperature that can be set on
the control panel.
5. DO NOT build into a wall, cabinet or any enclosed area.
6. Plug into a 120 volt wall outlet. This outlet should not be shared with a
refrigerator.
4
WC2002_ENG.qxd:Salton 9/6/11 12:59 PM Page 4
