Install the Ventilation Spacer
To ensure good ventilation, install
the provided ventilation spacer on
the rear of the unit as shown
in Illustration 1.
Install the Wall Bracket
Always avoid having bottles in the upper zone and none in the lower zone
to ensure stability. To avoid a hazard due to instability of the appliance, attach
to the wall using the enclosed Wall Bracket.
1. Fix the Wall Bracket on the appropriate location of the wall with the screw
provided. The bracket should be placed approximately 40” (101 cm) from
the floor surface.
2. Lift the unit and fit the end of the Wall Bracket into the slot located on the
back-cover of the Wine Cellar. The unit is now secured and ready to use.
HOW TO USE
1. Plug the Wine Cellar in 120 volt A.C. wall outlet.
2. The temperature is factory set at 10°C (50°F) and will be displayed in
the Fahrenheit scale. To switch the Display between Fahrenheit and Celsius
scales, depress the
p
and
q
arrows simultaneously for approximately
5 seconds.
3. To lower the temperature press the Temperature ‘Down’ arrow (
q
) or
to raise the temperature press the Temperature ‘Up’ arrow (
p
). Each
time you press the ‘Up’ or ‘Down’ arrow the temperature will change
by 1 degree within the temperature range of 4 - 22°C (39 - 72°F).
The Wine Cellar will work towards the temperature that has been set
and the Temperature Display will change.
5
Ill. 1
Ventilation
Spacer
SAL7-577 Booklet Salton Wine Cooler WC-2035_EN VF.qxd 08/08/07 14:29 Page 5
