BEFORE FIRST USE
1. Remove all packaging and labels. If there is any glue residue rub a small
amount of liquid dish soap with your fingers then wipe with warm water.
Dry.
NOTE: DO NOT
use any sharp instruments, rubbing alcohol,
flammable fluids or abrasive cleaners to remove tape or glue.
2. Clean the wine cellar, following the instructions in the “Care and Cleaning“
section.
INSTALLATION
1. The unit is designed to be free standing only. It should not be recessed
or built-in.
2. The ensure that your wine cooler works at the maximum efficiency,
follow the recommended clearances below:
- rear and both sides 5” (12.5 cm)
- top 2” (5 cm)
3. Place the Wine Cellar on a flat level surface that is strong enough to
support it when fully loaded.
DO NOT
place the unit in direct sunlight
and sources of heat (stove, heater, radiator, etc.).
4.
DO NOT
place next to any appliance that emits a large amount of heat,
such as a dishwasher, microwave, oven, toaster, etc. or in direct sunlight.
Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
5. Extreme cold ambient temperatures may also cause the appliance not
to perform properly.
6. To help with door closure, position legs with a 1/8" (3 mm) tilt to
the back. Adjust the leveling legs by turning clockwise to raise and
counterclockwise to lower.
7. Gently slide the racks into the unit.
4
SAL7-575 Booklet Salton Wine Cooler WC-2033_EN VF.qxd 01/08/07 16:53 Page 4
