Salton SOD 12, Инструкции и гарантия

Страница: 6 / 15

6
Note

If the new cylinder has just been connected, please allow at-least one minute
for the air in the gas pipeline to purge out through the pilot hole.

When lighting the pilot flame, ensure that the Variable Control Knob is
continuously pressed down while pressing the igniter button. The variable
Control Knob can be released once the Pilot Flame is alight.

The Pilot Flame can be check and viewed from the small round window with
the sliding lid, located at the bottom of the flame screen (to the left or right of
the controller).
 If the Pilot Flame does not light or goes out, please repeat from Step 3.
4.
After the Pilot Flame is lit, turn the Variable Control Knob to the minimum
position and leave there for 5 minutes before turning the knob to the desired
temperature position.
5.2 TO TURN OFF THE HEATER
1. Turn the Variable Control Knob to the Pilot position.
2. Press and turn the Variable Control Knob to the OFF position.
3. Turn the valve on the gas supply cylinder completely OFF.
5.3 STORAGE

Always close the gas valve of the gas cylinder after use or in the case of a
disturbance.

Remove the pressure controller and the hose.

Check the gas valve for both tightness and possible damage. If you suspect
damage, have it changed by your gas dealer.

Never store a liquid gas cylinder in a basement or in places where there is
inadequate ventilation.