3
17.
To disconnect, grip the plug and pull from the wall outlet. Never pull on the cord..
18.
Never attempt to open any part or to dismantle the controls. Responsibility for failure
cannot be accepted if these instructions have been ignored.
INTENDED USE
The ice crusher is for crushing cubes of pure water ice. The appliance must not be used for
crushing cubes containing fruit juices or anything other than water. To do so, could result in
damage / corrosion of internal components and could also invalidate your warranty.
USING THE ICE CRUSHER
1.
Place the ice crusher on a level, non-slip surface.
2.
Insert the mains wall socket (230V)
3.
Remove the clear plastic lid.
4.
Turn on the ice crusher by pushing the switch into the “On” position. Please always the
ice crusher is turn ON before putting the ice cubes into the ice crusher compartment.
5.
Using the ice scoop provided put 3 or 4 ice cubes into the hinged ice filler compartment.
Note: The size of the cubes should not be more than the standard 1” x 1” x 1”
( 25x25x25mm) variety.
6.
The hinged flap springs shut for safety.
7.
The ice crusher will process all the ice cubes and this only take a few seconds for each
load of ice cubes.
8.
Repeat the process until you have crushed enough ice for your needs or until the ice
container is full.
9.
Please make sure the ice cubes are fully crushed then turn “Off “the appliance.
10.
Important safety note: never put your fingers or any utensil into the processing chamber
to free any trapped ice.
CLEANING
1.
Before cleaning, always unplug the appliance.
2.
Wipe outside of the appliance with a paper towel or a soft cloth moistened with a little
water. It should not be washed in a dishwasher.
3.
Do not clean the inside or outside with any abrasive scouring pad or steel wool as this
will damage the finish.
4.
Do not immerse the unit in water or any other liquid although you can pour a little water
into the ice chamber. However, only use cold water and never use detergent.
