Designer Wood ADA Locker Bench (with back)
Assembly & Installation Instructions
Thank you for selecting Salsbury Designer Wood ADA locker benches. We are confident that the quality and construction of this product will provide
years of maintenance free use.
Preliminary Notes
There are two basic steps to assembly and installation:
1. The bench pedestals must be assembled to the bench top.
2. The bench assembly must be bolted to the floor.
Failure to bolt the bench assembly to the floor could result in
injury to persons sitting on the bench.
Since various types of floors require different types of fasteners, floor
installation hardware is not provided.
Two bench pedestals are provided with two bench tops, along with
three stiffeners pre-installed on the bench tops. All necessary holes
are pre-drilled in the wood bench top. Sixteen (16) 1/4” diameter x 1”
long lag screws are provided for attaching the bench pedestals to the
bench top.
CAUTION: using power tools to fasten screws into the bench top
may cause screws to strip and damage the wood. Install screws
by hand only and do not overtighten.
Assembly
Locate the bench top with the pre-installed flat stiffener plate and place
it upside down on a flat raised work surface, so that the stiffener is
facing up. Align the vertical members of the two bench pedestals with
the two outer rows of large holes, as shown in Figure 1. Fasten
pedestals to the bench top using eight (8) lag screws, and install round
hole plugs in all holes on the pedestals’ vertical members.
Place the remaining bench top upside down on the work surface. Align
the horizontal members of the pedestals as before, and as shown in
Figure 2. Fasten pedestals to the bench top using the remaining lag
screws, and install round hole plugs on the horizontal members.
Complete the installation by fastening the assembled bench to
the floor.
