SALSBURY INDUSTRIES
18300 Central Avenue, Carson, CA 90746-4008
Phone: 1-800-562-5377
Int’l Phone: 323-846-6700
Fax: 1-800-562-5399
Int’l Fax: 323-846-6800
www.lockers.com
engineering
@
lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright ©
2020
Salsbury Industries. All rights reserved. (Rev. 08, 7/2/15) Page 4 of 8
Locker Options – 77000 Series
Installation Instructions
Finished End Panel – Single Locker Depth
Installation of the single locker depth end panels requires drilling
holes into the side wall of a locker. Start by placing the finished end
panel against the side of the locker aligning its top edge with the top
of the locker and with the two end flanges facing the locker. Position
the notched corners at the front of the locker. Drill 1/4” diameter
holes through each hole in the finished end panel through the side
wall of the locker. Insert then tighten slot less screws and nuts
provided into each drilled hole. Installation is complete.
Finished End Panel – Double Locker Depth
Installation of the double locker depth end panels requires drilling
holes into the side wall of each locker. Start by placing the finished
end panel against the side of the lockers aligning its top edge with
the top of the lockers and with the two end flanges facing the locker.
Drill 1/4” diameter holes through each hole in the finished end panel
through the side wall of the lockers. Insert then tighten slot less
screws and nuts provided into each drilled hole. Installation is
complete.
