232928 10/19 | 85-001165_INST_A
EXP RUBBER STRAP INSTRUCTIONS
4
For additional product and safety information go to salsacycles.com/safety
SALSA CYCLES
6400 West 105th Street, Bloomington, MN 55438
Tel: 877-668-6223 Fax: 952-983-6210
www.salsacycles.com
Instructions for Use on a Frame Tube
1. Wrap the EXP Rubber Strap around the frame tube and pull
the strap through the buckle and hook, leaving plenty of slack
(Fig. 18).
2. Place cargo onto the desired frame tube location and pull strap
end to tighten around cargo. Cargo should never exceed 1 lb in
weight when mounting on a frame tube. We also suggest using
our Salsa Anything Pack to keep your contents protected and
easier to attach to a frame tube (Fig. 19).
Assemble strap as normal and tension onto cargo load and
refer to pages one and two for instructions on securing the
rubber strap.
3. Put loose strap end through the strap band so that it does
not flap and does not interfere with rider or rotating mass.
Ensure that if loose end came out of strap band it would move
away from rotating mass.
4. Ensure that the strap buckle and strap end are not protruding
into the rider’s leg zone (Fig. 20).
5. Ensure that cargo does not interfere with rotating mass
through travel of frame or fork (e.g. cargo on underside of
down tube should not touch the front wheel when fork is at
full bottom-out). Also ensure that cargo and strap do not
interfere with rider in anyway during use.
Ongoing Maintenance
The EXP Rubber Strap has been designed for years of service,
but it should be inspected regularly for wear and tear. Periodically
check the strap for cuts or voids and examine slots for cuts or
cracks around edges. To reduce risk of UV damage, do not store
the straps in the sun.
Warranty
Salsa Cycles warrants this new Salsa product against defects
in materials and workmanship for two (2) years from the original
date of retail purchase by the consumer. This limited warranty
is expressly limited to the repair or replacement of the original
product, at the option of Salsa Cycles, and is the sole remedy
of the warranty. This limited warranty applies only to the original
purchaser of the Salsa product and is not transferable. In no event
shall Salsa Cycles be liable for any loss, inconvenience or
damage, whether direct, incidental or consequential or otherwise
resulting from breach of any express or implied warranty or
condition, of merchantability, fitness for a particular purpose, or
otherwise with respect to this product except as set forth herein.
This warranty does not cover the following:
• Damage due to improper assembly or follow-up maintenance
or lack of skill, competence or experience of the end user
• Products that have been modified, neglected, used in
competition or for commercial purposes, misused or abused,
involved in accidents or anything other than normal use
• Damage or deterioration to the surface finish, aesthetics
or appearance of the product
• Normal wear and tear
• Labor required to remove and/or refit and re-adjust the
product within the bicycle assembly
To the extent not prohibited by law, these warranties are exclusive
and there are no other express or implied warranties or conditions
including warranties or conditions of merchantability and fitness
for a particular purpose.
Proof of purchase is required before a warranty claim is processed.
Salsa Cycles therefore strongly encourages warranty registration
at salsacycles.com. Failure to register will not affect consumer
rights under the limited warranty stated above, so long as the
consumer can show in a reasonable manner proof of original
ownership and the date the Salsa Cycles product was purchased.
If you have any questions contact [email protected]
Figure 18
Figure 19
Figure 20
