Product overview
Product assembly
BASE ASSEMBLY
•
First, loosen and remove the four screws from the stand cross bars A
and B. Then position both bars in a cross so that they interlock.
•
Make sure to align the four screw holes in the bars with those of the
rim on the outer tube. Secure the rim to the bars with the four
screws.
•
Loosen and remove the height adjustment collar on top of the inner
tube. Slide the base decorative cap downwards over the assembly.
•
Reposition the height adjustment collar on top of the inner tube. By
pulling the inner tube out from the outer tube you can adjust the
height you desire, then tighten the collar.
•
If necessary slightly loosen the set screw by turning it anticlockwise.
Slide the control box downwards over the inner tube and tighten the
set screw, make sure the set screw is tightened securely.
BLADE AND FAN GUARD ASSEMBLY
•
Unscrew the plastic mounting nut from the motor housing by
rotating it anticlockwise.
•
Position the rear fan guard against the front of the motor housing
with the handle upright, ensuring that the pins of the motor fit in the
holes of the rear fan guard.
•
Tighten the plastic mounting nut clockwise.
MAKE SURE NOT TO
OVERTIGHTEN IT.
•
Push the fan blade onto the motor shaft, locating the slot at the back
of the blade on the drive pin that passes through the motor shaft .
•
Tighten the blade cap by turning it anticlockwise.
•
Position the front fan guard against the rear fan guard so that the
holes in the rims, with the small nut and bolt, are aligned. Insert the
1.
Front fan guard
2.
Blade cap
3.
Fan blade
4.
Plastic mounting nut
5.
Rear fan guard
6.
Motor shaft
7.
Oscillating knob
8.
Motor housing
9.
Neck screw
10. Control box
11. Set screw
12. Inner tube
13. Height adjustment collar
14. Outer tube
15. Base decorative cap
16. Screw
17. Stand cross bar A
18. Stand cross bar B
19. Screw