EN
3
SLEEP TO RADIO
The radio can be set to switch off automatically after a period of time from 1 minute to 1 hour
59 minutes, by following this procedure:-
Set the FUNCTION Selector (11) to “OFF” position or, if the Alarm is to be activated, the “AUTO”
position or “ALARM” position. Then depress the Sleep Set Button (8) and the Minute Set Button
(9), or Hour Set Button (10) until the display shows the exact sleep time you wish the radio to
continue to play before switch off. To switch off the radio before the end of the registered sleep
time period, simply press the Snooze Button (5) once.
CLEANING
Clean the cabinet with a soft cloth moistened with water or mild detergent. Do not use solvents
such as alcohol, benzene
or thinner, as they may damage the cabinet finish. Make sure to
disconnect the mains lead from the supply before cleaning.
CAUTION
1. Ensure minimum distances around the apparatus for sufficient ventilation. The ventilation
should not be impeded by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc.
2. No naked flame sources, such as lighted candles, should be placed on the apparatus.
3. It shall not be exposed to dripping or splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
4. Do not place the product in closed bookcases or racks without proper ventilation.
5. Where the mains plug is used as the disconnect device, the disconnect device shall remain
readily operable.
6. Attention should be drawn to the environmental aspects of battery disposal.
7. The use of apparatus in moderate climates.
8. Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
9. Batteries (battery pack or battery installed) shall not be exposed to excessive heat such as
sunshine, fire or the like.
10. The location of the rating label is affixed on the bottom surface of appliance.
SPECIFICATION
Power Source:
AC 230V~50Hz
Frequency Range:
AM 530 – 1600 KHz
FM 88 – 108 MHz
We reserve the right to modify product design and/or specifications without prior notice.
