salling 10100956, Инструкция по эксплуатации

Страница: 23 / 25

23
OPERATING INSTRUCTIONS
Step 1
Open the lid and take out the basket and add water to the reservoir.
Note: There is a maximum scale MAX in the reservoir. The water should not exceed the
MAX position. If the water exceeds the maximum scale MAX, you need to open the
bottom drain plug, release the excess water, and cover with a transparent cover.
Step 2
Plug in the power, touch the touch screen, the power button lights up, touch the power
button, the machine enters the standby mode.
Step 3
Select the size of the ice you want to make, the default is large ice.
CAUTION
1. When the indoor temperature is lower than 15 degrees, please choose small ice. When
the indoor temperature is higher than 30 degrees, it is recommended to choose large
ice.
2. The three cycles used for the first time, the ice produced is small and irregular.
3. When the ice collecting tray is full, please take out the ice immediately, do not let the
ice overflow the ice collecting tray.
CLEANING & USE GUIDANCE
1. Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequent-
ly. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of
water and vinegar to clean the inside and the outside surface of the Ice maker. Do not
spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse
thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may not have enough
water to pump for air retard, in this case, repress POWER button to restart the ice
maker is okay.
4. To ensure the cleanness of ice, please change water for water reservoir at least once
one day. If do not use for a long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, fully water or interruption of
power supply, it will delay for 3 minutes to start up after restarted.
6. Always use fresh water before starting ice production either at initial installation or after
a long shut-off period.
TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the power cord, or the
power button has been pushed off during an ice making cycle, small ice chips may
form and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips