Salda RIRS 1200 V EKO 3.0, Монтаж и инструкция по установке

Страница: 11 / 60

EN | 11 RIRS 1200-5500 V EKO 3.0 v2019.06
PS
PS
PS
PS
PS
PS
PS
PS
PS
2
2
2
2
2
Figure. 15.4. RIRS 2500-5500 VW EKO 3.0
M
CO
2
Figure. 15.5. Indication for duct connection. Figure. 15.6. Ventilated premises
ODA - outdoor air; SUP - supply air; ETA - extract air; EHA - exhaust air.
LIST OF COMPONENTS
C
Plate heat exchanger A1 Fire alarm damper actuator I
PV Supply air fan A2 Fire alarm damper actuator II
IF Extract air filter TJ Supply air temperature sensor
PF Supply air filter TL Outdoor air temperature sensor
IV Exhaust fan TE Exhaust air temperature sensor
KE1 Electric heater DTJ Extract air temperature and RH sensor
PE1 Electric pre-heater T2 Cooler changeover thermostat
KV2 Water pre-heater TV2 Water preheater temperature sensor
KV3 Water cooler TV3 Water cooler temperature sensor
DX DX cooler U3 PV pressure transmitter
M1 By-pass damper U4 IV pressure transmitter
M2 Outdoor air damper actuator CO
2
CO
2
sensor*
M3 Exhaust air damper actuator RH RH sensor*
M5
Water cooler valve motor
PC
Computer
M12 Water pre-heater valve actuator RC2 Stouch, Flex or SA-Control remote control panel
M14 Water cooler circulation pump MB-Gateway Network module
M15 DX cooler valve actuator NET Network
M16
Water pre-heater circulation pump
POSSIBLE PCB INPUTS/OUTPUTS
FA
Fire alarm
H1
Working indication output
FPP Fireplace protection H2 Alarm indication output
System mode switch (START/STOP) Fans speed switch (BOOST)
* Component/posibility to connect it depends on model. For more information please, check the manual
16. CONNECTION OF THE UNIT TO ELECTRIC NETWORK
• Supply voltage to the unit must be connected by a qualified specialist following the manufacturer’s instructions and effective safety instructions.
• The unit’s power network voltage must correspond to electrotechnical parameters of the unit indicated in the technical decal.
• The unit’s voltage, power and other technical parameters are provided in the unit’s technical decal (on the unit casing). The unit must be connect-
ed to the voltage plug socket of the grounded power network in compliance with the effective requirements.
• The unit must be earthed according to the rules on installing electrical equipment.
• It is prohibited to use extension wires (cables) and power network plug socket distribution devices.
• Prior to carrying out any ventilation unit installation and connection activities (until its hand-over to the customer), the unit must be disconnected
from the power network.
• After installation of the ventilation unit, the power network plug socket must be accessible at any time and disconnection from the power network
is performed through the two-pole circuit breaker (by disconnecting phase pole and neutral).
• The unit must be thoroughly checked against damages (execution, control, measurement nodes) during transportation before it is connected to
the power network.
• The power cable can be replaced only by a qualified specialist upon the evaluation of the rated power and current.