EN |
15
AMBERAIR COMPACT CXP v2024.2
0,5 - 1
o
Figure 5.5.2. AmberAir Compact CX P mounting
5.6. UNIT PLACING AND MOUNTING POSITIONING REQUIREMENTS
L
1,5xL
L
1,5xL
H
H
Figure 5.6.1.
Min. distance to open the door - 1,5xL; Min. distance to open the control box door - H > 400 mm.
5.7. CEILING-MOUNTING OF THE UNIT
•
Before starting installation work, first unpack the product as shown in the section
•
After screwing up the suspension brackets, the product with the whole remaining pallet is raised to the ceiling using a forklift.
•
After mounting the product to the wall, the forklift with the remaining pallet is withdrawn.
max. 50 cm
30 mm
50 mm
30 mm
50 mm
•
Rails are offered as an accessory to be screwed up to the suspended product after installing the cover holders to the appropriate position.
•
If the thickness of the cover is 30 mm, insert the holder into the upper hole. If the thickness of the cover is 50 mm, insert the holder into the lower
hole.
•
To screw up the rails, washers and screws are used.
•
When using the rails, the hinges should be unscrewed from the cover after screwing up its ends. The accessories bag contains screws for fas
-
tening the end of the cover that was previously held by the hinges.
