Page 3 of 10
Olivia - v8/20
If you have purchased a Tactile
Sound Transducer for your chair(s),
install before connecting seats.
Remove lower back panel. Screw
on jam nut included with transducer
kit. Approximately 3/8” (10 mm) of
threads should be exposed on bolt
on chair frame. Screw transducer
onto bolt to meet jam nut. Make
sure transducer sits at least 1/8”
(3 mm) above inner chair frame
cross rail (adjust if necessary),
tighten jam nut and transducer to
lock in-place.
Tactile Transducer - Optional
2
Power Seating - Optional
3
A.
Connect recliner controllers
to motors.
B.
Connect power supplies
to motors.
Coil & Tie Extra Wire Length.
Be careful to route wires away
from mechanism.
2-pin adaptor cord