Sakura SXAO-110HAS, Инструкция по установке и обслуживанию

Страница: 20 / 31

19
is not available on your installation. In that case the controller will give the alarm sound and no any
action will effect on the unit.
Switching on and setting space cooling ( ) and heating ( )
1. Use the button to select space cooling or space heating.
Icon or appears on the display as well as the corresponding water temperature set point.
2. Use the or button to set the desired water temperature.
·
Temperature range for heating: 25
℃
to 55
℃
.
·
Temperature range for cooling: 5
℃
to 22
℃
.
3. Switch on the unit by pushing the button. The operation LED
○ ○
lights up.
Selection and setting of domestic water heating
1. Use the button to activate domestic water heating . Icon appears on the display.
2. Use the or to set the desired domestic water temperature.
Temperature range for domestic water heating: 30
℃
to 80
℃
.
NOTE Remark that pushing the button has no influence on the domestic water heating.
Domestic water heating is only switched on or off by means of the button.
Selecting powerful domestic water heating operation
Press for 5 seconds to activate powerful domestic water heating operation.
Icons and start flashing.
Power domestic water heating is deactivated automatically when the set point for the domestic
hot water is reached.
Checking actual temperatures
Each time the button is pressed, the screen will display the next temperature item. The sequence as below:-
T1 Indoor temperature
T2 Outdoor temperature
T3 Outdoor coil temperature
T4 Water pump outlet temperature
T5
T6
T5, T6 display “—“
The hot water temperature display section will show the certain No. and the relating actual temperature. The display
temperature range is -9
℃
-85
℃
. If no button is pressed for 30 seconds the temperature check will return to display
setting temperature.
Schedule timer operation
In schedule timer operation, the installation is controlled by the schedule timer. The action
programmed in schedule timer will be executed automatically.
The schedule timer always follows the last command until a new command is given. This means that
T1 T3 T2 T6 T4 T5