SAK TECHNOLOGY VRPK Series, Руководство пользователя

Страница: 8 / 12

8
Disconnect the fa n from the power supply prior to any work
on the unit.
All the electrical connections of the fan must be made by a qualified
electrician.
The nominal values of electrical para meters are given on the fan
manufacturer's label.
Any tampering with the internal connections is prohibited and will
void the warranty.
The power supply depends on the fan type: 230V/50 Hz single-phase or
380V/50Hz three-phase AC voltage.
The fan connections (cables and wires) must be durable, insulated and
heat-resistant.
The external lead-in (230V/50Hz or 380V/50Hz) must be equipped with
an automatic circuit breaker integrated into the stationary wiring.
The position of QF external switch must ensure free access for quick
power-off of the fan.
The recommended automatic breaker nominal current and conductor
sections are given in Table 3.
2
The power conductor section is 1.5 mm.
However, the conductor section selection shall account for the maximum
permissible wire heating which depends on the wire type, its insulation,
length and installation method (i.e. overhead, duct layout or inside the walls).
The trip current shall be consistent with the current consumption of the
unit as given in Table 2.
The fan connections shall be made on the terminal block mounted inside
the terminal box on the fan casing in strict accordance with the electrical
connection diagram and terminal designations.
The label with terminal designations is inside the terminal box.
The QF automatic switch is not included in the delivery package and is
installed by the user.
The fan wiring diagrams are given on Fig.4 and 5.
Connect the fan to the power mains as shown on Fig.6.
ELECTRICAL MAINS CONNECTION