SAINT-GOBAIN NORTON CLIPPER CM 501 ME, Руководство по эксплуатации

Страница: 21 / 28

VERS. 2017.06.21 CM 501 ME_MAN_EN
21
6 MAINTENANCE AND SERVICING
To ensure a long-term quality from the cutting with the CM501, please follow the maintenance plan
below:
B
egi
n
of
t
he d
ay
D
ur
ing t
he
c
ha
ngi
ng of
t
oo
l
E
nd
of
t
he day
or
m
or
e of
ten i
f r
eq
ui
re
d
E
v
er
y
w
eek
A
ft
er
a f
aul
t
A
ft
er
a dam
age
Whole machine Visual control (general aspect,
watertightness)
Clean
Flange and blade fixing devices Clean
Belts tension Check and adjust
Motor cooling fans Clean
Water pump Clean
Water pan Clean
Water hoses and nozzles Clean
Water pump filter Clean
Cart guiding bars Clean
Motor housing Clean
Reachable nuts and screws Tighten up
Maintenance of the motor
Always perform the maintenance of the motor with the machine isolated from the electrical supply.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially water
pump, water pan, motor and blade flange.
Lubrication
The CM501 uses life-lubricated bearings. Therefore, you don’t need to lubricate the machine at all.
Adjustment and replacement of the belts
To adjust the belts, firstly remove the belt guard by unscrewing the 4 screws. To remove the belt
guard, you need to remove the upper part of the pivot bearing. Loose the 4 motor bolts and shift the
motor by using the two screws on the side.
To replace the belts, move the motor forward on the cutting head. Adjust the belts and retighten
them by shifting the motor to the rear of the machine.
Always use a matched set of belts. Do not replace single belts.