16
5
Operating the CK31
5.1 Site of work
Before you start working, please check the following points:
Remove from the site anything, which might hinder the working procedure.
Make sure the site is sufficiently well lit.
Make sure you have a continual adequate view of the working area so you can intervene in the
working process at any time.
Keep other staff out of the area, so you can work securely.
5.2 Cutting method
In this section, you can find instructions to make a straight cut at the desired depth.
5.2.1 Preparing your cut
Before starting the machine,
Draw a line on the floor over the cutting length.
Make sure you have filled the engine tank with fuel, and the water tank with water, or that you
have connected the blade guard to the water supply. No diesel is supplied with the machine.
The engine is shipped with oil. Check oil level before starting. Top up if required (see 6.2.).
Make sure you have assembled the correct blade as recommended by the manufacturer
depending on the material to be worked, the working procedure (dry or wet cut) to be carried
out, and the efficiency required.
Make sure that the flanges securely hold the diamond blade.
Make sure that the blade is not touching the floor before starting the engine.
Roll the machine until the blade is over the line.
Lower the guide-a-cut so it touches the line. The back guide should also be on this line.
Set the speed handle in the middle position, so that if you engage the clutch, the machine will
not move unexpectedly. Make also sure that the clutch is disengaged and the parking brake is
tightened.
