SAIC MOTOR MG HS, Руководство пользователя

Страница: 235 / 319

Starting & Driving
Parking Aid System
Ultrasonic Sensor Parking Aid
The purpose of the parking aid system is to
assist the driver during reversing! The sensors
may not be able to detect certain types
of obstruction, e.g.
narrow posts or small
objects no more than a few inches wide,
small objects close to the ground, objects
above the tailgate and some objects with
nonreflective surfaces.
Keep the sensors free from dirt, ice and snow.
If deposits build up on the surface of the
sensors, their performance may be impaired.
When washing the car, avoid aiming high
pressure water jets directly at the sensors
from close range.
Rear Parking Aid
The ultrasonic sensors on the rear bumper monitor the
area behind the vehicle to search for obstacles.
If an
obstacle is detected, the system will calculate its distance
from the rear of the vehicle and communicates the message
to the driver by sounding warning chimes.
Parking Aid Operation
When the ignition switch is in position ON/RUN/START,
the rear parking aid is enabled automatically when reverse
gear is selected, and it is switched off as soon as reverse
gear is disengaged. A short beep is given by the parking aid.
1 second after selecting the reverse gear to indicate that
the system is operating normally. If an obstacle is detected
at the rear, the system will prompt the driver with warning
alarms.
Note: If a longer, higher pitched sound is emitted (for
approximate 3 seconds) when reverse gear is selected,
this indicates a fault in the system. Seek assistance
from your MG Authorised Repairer.
221
4