Sagola XTech Series, Инструкция по эксплуатации

Страница: 27 / 112

ENGLISH
26/27
Spraying mixes Lines
To spray a fine or wide line, start moving the airbrush with the trigger pushed down for air. Then pull
the trigger back for paint flow at the beginning of the line and stop paint flow at the end, but continue
the motion of the airbrush.
- A longer distance to the surface produces wider lines .
- A shorter distance to the surface produces narrower lines .
- Increased air pressure increases spray width.
- Decreased air pressure decreases spray width.
During application, the amount of product can be
reduced by turning the product regulator, reducing
the pressure applied in the trigger with one's finger.
Stippling (Dots)
The Sagola XTech airbrushes are designed to produce a wide range of stippling textures .
Stippling (coarse or fine dots) can add special textured effects to artwork.
Simply remove the needle cap and air nozzle cap and adjust the air pressure between 0,3-2 bar (5
and 30 psi) Lower air pressure will produce coarse dots; higher pressure will produce fine dots. Paint
viscosity affects stippling, as well.
8. Maintenance
In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the compressed
air distribution network .
Do not apply excessive force or inadequate tools for maintaining and cleaning the unit. Some repairs
must be done with special tools on some occasions.
In these cases, you must contact the Customer Service of SAGOLA.
Any handling of this product by
non-authorised personnel would render the warranty null and void .
The unit must be overhauled on a periodic basis to check the status of its components and replace
these when they are not in perfect condition.
IN ORDER TO OBTAIN THE BEST POSSIBLE RESULTS, ALWAYS USE ORIGINAL
SPARES. ENSURE TOTAL INTERCHANGEABILITY, SAFETY AND OPERATION.
8.1 Lubrication
Grease the threads and friction areas using consistent grease.
* If your trigger does not move backward and forward smoothly, lubricate the needle packingland
screw and needle locknut.
1. Unscrew the handle.
2. Loosen the needle locknut.
3. Remove the needle.
4. Place only one drop where the needle locknut begins and spread evenly around tapered edge.