instructions, ensuring that any foreign bodies are prevented from spoiling the
quality of finish and application. Should there be any doubt relating to the
purity of the product, its composition, etc., please contact your supplier.
· Control the viscosity of the product
to be applied with the SAGOLA Viscosime-
ter - Code 56418001
6. Useful tips
· You are recommended to
use the gun with the product regulator open (without removing it
completely from its housing)
in order to minimise wear to the fluid tip and needle and to ensure
maximum amplitude.
-
Use the lowest spray pressure
in the nozzle that allows you to obtain the required finish. Not
all products require the maximum pressure for correct spraying. With a lower pressure, less air
is consumed and there is an additional increase in product transfer.
-
The gun leaves the factory ready
to spray products correctly with the air nozzle corresponding
to each application. It is adjusted to an
air inlet pressure of 2 bar
to ensure
maximum
performance
.
· Pay special
attention to the application speed
. The thickness of the film deposited may be
greater than planned if the application speed is low, and the opposite is also true.
·
If the film is thick or granulated
, this is due to the fact that the air pressure is excessive for the
amount of product being applied.
Reduce the air pressure
in the gun in order to ensure that the
solvent in the paint does not evaporate during spraying and that this is not dry when it reaches the
surface to be painted.
Increase the amount of product, correct its viscosity or use a larger fluid tip
in the gun.
·
If the thickness of the layer is very thin
, this is due to the fact that the air pressure is excessive
for the amount of product to be applied.
Decrease the amount of product, reduce its viscosity
or
use a smaller fluid tip in the gun.
·
If sagging occurs
, this is due to the fact that the amount of product to be applied is excessive for
the air pressure used, that the viscosity is not correct or the application speed is not adequate.
Decrease the amount of product, adjust its viscosity or increase the application speed
until the
required finish is obtained.
The spraying width
(spraying pattern) obtained
will depend on the air nozzle used. If nozzles are
required for other applications, contact the Technical Service of SAGOLA S.A.
The size or amplitude
of the spraying pattern
can be modified with the spray width regulator
, by
turning the control anticlockwise to increase this or clockwise to reduce this..
7. Functional Description of the Equipment
The
SAGOLA
gun model
4600 Xtreme
can be used for applying appropriately diluted products
(paints, lacquers, varnishes, adhesives, etc.), used widely in the
automotive industry, timber
industry, plastics, etc.
Compressed air
for spraying is connected to the air input connector under the gun grip.
The product
to be applied is placed in the
cup
provided for this purpose, from which it flows by
gravity to the
fluid tip
and is then mixed with spraying air in a way that can be controlled from
outside the
air nozzle
.
When the trigger is pulled back
to the first position, it engages the air valve stem, opening this and
allowing air to flow through.
ENGLISH
