Sagola 4240, Инструкция по эксплуатации

Страница: 18 / 62

ENGLISH
08. Start up
Before use
The following should be performed in an uncontaminated area:
• CHECK that the air supply pressure and flow available are in accordance with the above air
supply specification EN12021.
• INSPECT the equipment before use for any signs of damage or deterioration. Do not use the
equipment if it appears damaged.
• FIT the belt with the regulator attached around the operator’s waist with the regulator on the side
of the body. Lock the buckle and adjust the belt to a comfortable tightness.
• CONNECT the male end of the main air supply hose to the main air supply. CONNECT the female
end of the main air supply hose to the male inlet of the regulator.
• EXAMINE the visor and replace the visor cover (Ref.15880013) if contaminated, by pulling it off
and pushing a new visor cover over the two metal studs.
• CONNECT the visor to the outlet of the regulator ensuring that it is locked in place.
• CHECK the air quality from the visor. If an odour is detectable the cause should then be
investigated since further pre-filtering will probably be required.
If an accessory such as a spray gun or power tool is to be driven
from the same compressed air supply tube, ensure that the airflow
indicator shows that sufficient flow is being delivered into the visor
when the accessory is consuming the maximum airflow requirement.
Fitting the browguard assembly
Open out the head harness by pressing and rotating the knob on the back of the harness.
• To fit the head harness, adjust the crown strap and the knob at the back of the head harness
until the face seal fits around the face when the visor is flipped down.
• The light duty breathing hose should run down the back of the user.
If an oil odour develops during use the quality of the supply air and
any upstream in-line filtration should be checked to ensure that the
air being fed to the breathing equipment is free from oil mist. If fitted,
the regulator filter cartridge may need replacing.
09. Maintenance and cleaning
All maintenance should be performed in an uncontaminated area.
• Visor covers (Ref:15880013) should be replaced when contaminated.
• The complete kit of equipment should be inspected on a monthly basis (or before use for
occasional users) and any worn or damaged components are replaced. Particular attention should
be paid to the visor and its face seal.
• The equipment has a five years shelf life from the date of manufacture.
• The equipment should be stored and transported in a way that will not affect its working
performance.
• It should preferably be kept in its original packing at an even ambient temperature and humidity.