2
GENERAL DESCRIPTION
Technical Features and Dimensions
Voltage
rating
230
V
Rated
current
7,4
A
Frequency
50
Hz
Maximum surface temperature
70º C
Distance from inflammable surfaces
2 mt
Weight
52,5 Kg
Protection
rate
IP20
HMI 1200/S short discharge lamp, socket SFc 10-4
CAUTION
The projector cannot be mounted on inflammable surfaces.
Norms applied to construction:
EN 60 598-1
EN 60 598-2-17 EN 294 EN 50 082-1
EN 55 015
EN 60 555-2
EN 61 000-3-2
Working Position
Moving Wash 1200 can work in all positions.
Admissible Environmental Conditions
The projector was engineered and produced to function in covered, dry areas with an air temperature ranging
between 5° and 35° C, and with a humidity level between 30 and 90%.Sharp changes in room temperature may
generate condensation inside the projector, which can harm the projector. Therefore, switch on the projector only
after it has undergone a period of gradual adaptation to the room temperature.
Storage
The projector, in its original packing, must be kept in covered, dry areas with a temperature between -10° C and
+50° C.
Mechanical Safety Guards
A bipolar cut-off switch is located between the lamp compartment and the cooling unit. This safety switch cuts off
the power to the projector if the top lid is opened.
Noise Level
After the projector has been powered up and the initial configuration takes place, the noise produced by the
projector is primarily due to its cooling system. The noise level is much lower than the limit of 70 dB permitted by
law.
Handling
The projector, with or without packing, must be handled with care. Lifting and handling must be carried out with
special equipment. Do not expose the projector, with or without its packing, to brusque accelerated or decelerated
movements, knocks, dragging, or other stress caused by unsuitable handling methods.
