SAGEMCOM Dr. Neuhaus ZDUE-LTE-PLUS-VII, Руководство пользователя

Страница: 16 / 62

Commissioning
Page 16 of 62
3
Commissioning
To put the ZDUE-LTE-PLUS-VII operation, proceed as follows:
Page
1. Read the safety instructions at the beginning of this document. 4
2. Insert SIM card 16
3. Configure the ZDUE-LTE-PLUS-VII if required 33
- Connect the ZDUE-LTE-PLUS-VII supply voltage 17
- Carry out the configuration 33
- Disconnect the ZDUE-LTE-PLUS-VII from the supply voltage again. 17
3. Connect meter 17
4. Attach and connect the antenna 18
5. Connect the ZDUE-LTE-PLUS-VII supply voltage 17
3.1 Inserting the SIM card
Warning
Never insert or remove the SIM card during operation!
PIN The factory setting of the ZDUE-LTE-PLUS-VII is such that SIM cards with
PIN
0000 are accepted.
If the SIM card has a different PIN, you can adjust the setting of the ZDUE-
LTE-PLUS-VII in parameter class 79 to the PIN of the SIM card (see
Chapter 7.3.2). Alternatively, you can change the PIN of the SIM card with a
mobile phone.
With some network operators it is also possible to switch off the PIN query of
the SIM card. In this case, the PIN can be arbitrary, as it is not considered.
To insert the SIM card, proceed as follows:
1. Disconnect the device from the supply voltage at all
poles if it is connected there.
2. Loosen the screw of the clamp cover and remove the
clamp cover.
3. Then remove the appliance lid.
4. Open the SIM card holder and slide the SIM card into
the flap of the holder. The gold-plated contacts of the
SIM card must be on the gold-plated contacts of the
holder when the SIM card holder is closed.
5. Close the flap of the SIM card holder again and lock the
flap by carefully sliding it to the left. You will feel it click
into place.
6. Replace the device lid and the clamp lid.
!
SIM-
Card holder