Sagem MyCK100, Руководство пользователя

Страница: 3 / 10

Switching ON/OFF the myCK100 handsfree kit
The myCK100 handsfree kit will be switched on (from off state) by doing a medium-long press on Button
1. A short low tone beep followed by 1 high low tone beep is played by the handsfree kit.
The myCK100 handsfree kit will be switched off (from on state) by doing a medium-long press on Button
1. A short high tone beep followed by 1 short low tone beep is played by the handsfree kit.
Pairing of myCK100 Bluetooth handsfree kit
Before using the myCK100 handsfree kit, you must pair it with your Bluetooth® mobile phone. Pairing is
the process of linking two Bluetooth® devices, so that they can communicate.
The pairing procedure only needs to be done once. Afterwards, every time you switch on your handsfree
kit (Push medium-long on Button 1), it will automatically connect to your mobile phone. If the user loses
the Bluetooth® connection with his mobile (Ex: An user leaves the handsfree kit in his car and takes his
mobile phone with him). The user should push once the main push button
§
to connect the handsfree kit
with his Bluetooth® mobile phone. If you pair your Bluetooth® mobile phone with another Bluetooth®
device, you will have to pair the handsfree kit with your phone again before use.
IMPORTANT: Before pairing, all Bluetooth® devices must be switched off.
To initiate the pairing, put both the myCK100 handsfree and the mobile phone within 0.3 meter (1 foot) of
each other. Make sure there is no Wi-Fi equipment operating in the vicinity.
1. Switch on the myCK100 handsfree kit (Push medium-long on Button 1). Pairing will be
automatically initated by the myCK100 handsfree kit itself when detecting no pairing history
list (No mobile phone paired, yet). The handsfree kit will indicate the pairing Mode by
alternately blinking blue and red LED indicator in every 1-second interval.
If a mobile phone is already listed in the handsfree kit. The handsfree kit enters in pairing
Mode after a long press on button 2. The Pairing Mode is indicated by alternately blinking
blue and red LED indicator in every 1-second interval. If your Bluetooth® mobile phone is
switched off the handsfree kit stays in pairing mode around 3 minutes.
2. Switch on your phone and select the Bluetooth® mode (Service discovery) on the Mobile
phone (See the Bluetooth® mobile phone user guide).
3. Once the mobile phone detects the myCK100 handsfree kit, a message is displayed with
the following information:
myCK100 .
4. Follow the phone instructions to accept the pairing. The PIN code (or password) is 0000
5. When the pairing is completed, the indicator light are not activated and a short bip tone is
played. Then short high bip tone is played in 2-second interval until connection is
established or failed.
6. The user could check if the myCK100 handsfree kit is connected to his Bluetooth® mobile
phone in pushing the main push button
§
(Short press). Then the handsfree kit plays a short
and a long bip tone. If the connection is failed the handsfree kit plays a short and a short
high bip tone.