Sagem MORPHOACCESS 200, Руководство по установке

Страница: 10 / 118

S
S
A
A
F
F
E
E
T
T
Y
Y
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
The installation of this product should be made by a qualified service
Person and should conform to all local codes.
It is strongly recommended to use a class II power supply at 12 V ±5% and
2.5 A/min according with Safety Electrical Low Voltage (SELV). The 12 V
power supply cable length should not exceed 3 meters.
This product is intended to be installed in accordance with the NEC Class
2 requirements; or supplied by a listed external Power Unit marked Class
2, Limited Power source, or LPS and rated 12 V DC, 2.5 A minimum.
In case of building to building connection it is recommended to connect 0V
to ground. Ground cable must be connected with the terminal block board
fixation screw marked with universal ground symbol.
Warning :: The user could connect the MorphoAccess™ 0V to
Ground only if the MorphoAccess™ was before connected and tested in
working.
Europe : SAGEM hereby declares that the SAGEM MorphoAccess™
has been tested and found compliant with the below listed standards as
required by the EMC Directive 89/336/EEC: EN55022 (1994)/EN55024
(1998) and by the low voltage Directive 73/23/EEC amended by
93/68/EEC: EN60950 (2000).
USA : This equipment has been tested and found compliant with Class B
digital device requirements, pursuant to part 15 of the FCC Rules. These
requirements are designed to ensure reasonable protection against
harmful RF interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
interfere with radio communications. If this equipment interferes with radio
or television reception - which can be determined by disconnecting and re-
connecting the unit – the user is encouraged to try to correct the
interference by one or more of the following measures :
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
10
SAGEM Défense Sécurité document. Reproduction and disclosure forbidden. SK-0000011145-05