Loosen screws
Loosen screws
16
Under normal usage, the lamp life time of the projector
is about 1500 hours. The output luminance will drop as
lamp life diminishes. User can check the used lamp life
status in the MANAGEMENT MENU of OSD.
Change the lamp cartridge when the brightness is no
more acceptable. User can consult qualified agent or
manufacturer for model of lamp cartridge and purchase
new ones for replacement.
User can follow the steps below and replace the lamp
cartridge.
WARNING
* THE POWER CORD MUST BE DISCONNECTED to
prevent the danger of electric shock while user replacing
the lamp cartridge.
* DO NOT TOUCH THE LAMP immediately after it is
used. It will be extremely hot and might cause harm.
* DO NOT RELEASE ANY SCREWS except those in the
instruction below. This is to prevent user from the danger
of electric shock.
* Replacing ONLY THE SAME OR EQUIVALENT TYPE:
SAGEM SLP 504 P/N: 251394995
REPLACING THE LAMP UNIT
1. Turn off the power and disconnect the power cord.
Wait at least one hour for the lamp to cool down.
2. Turn the unit bottom up carefully and loosen the
two fixing screws on the lamp cover.
3. Remove the lamp cover and loosen the two fixing
screws on the lamp cartridge.
Handle
4. Hold the handle and pull the lamp cartridge up
carefully to remove it.
5. Install the new lamp cartridge.
Secure screws
6. Secure the new lamp cartridge with screws.
7. Secure the lamp cover with screws. Return the unit
to normal position and restart the unit. User can
reset the lamp counter (RESET LAMP) in the
management menu of OSD manually.
