31
Care and Maintenance
Use a slightly damp cloth to wipe the base and handset, do not use a dry cloth as this may
cause electrostatic charges.
Problems
Refer to the table presented below in case of an operational malfunction:
Problems
Remedies
The handset display is
blank.
Make sure the batteries are properly installed.
Place the handset on the base and fully charge the batteries.
To increase the life of your batteries, you can perform this
operation about every two months.
If these precautionary measures do not resolve this issue,
replacement batteries are available through your reseller. To
replace your batteries, refer to see pargraph "Replacing the
batteries", page 9.
As time goes by, you may notice a slight decrease in battery
performance. Use your handset until the battery is fully
discharged, and then charge it for at least 12 hours.
The handset does not
ring during an incoming
call.
Make sure that the telephone is properly connected and that
you have a dial tone.
Make sure your telephone is not set to silent mode ( see
pargraph "Sound Settings", page 23).
No radio link between the
handset and base.
The network indicator
icon flashes
Make sure the handset is registered by moving closer to the
base, if it is registered correctly, the handset screen should
display its own handset number.
Otherwise, register the handset to the base. see pargraph
"Register a new handset to a base", page 25.
You obtain a "busy" dial
tone for each dialled
number.
Make sure no one else is using another handset (if the
intrusion mode is deactived).
Make sure that the dial mode (tone or pulse dialling) is
compatible with your telephone line or your automatic branch
exchange.
You cannot send
or receive SMS.
Make sure you have subscribed to a caller display service.
Find out if the SMS service is in fact activated on your line.
Obtain the server numbers from your service provider and
make sure they are identical to the numbers on your handset.
A
PPENDIX
LU 252976139A D86C EN.book Page 31 Vendredi, 3. août 2007 9:56 09
