3-55
Using the Operator Panel
Selecting the Unit of Measurement
Press
.
Press
or
repeatedly until >>Unit appears. The unit of measurement can
be selected between millimeters and inches. The current unit of measurement
is displayed (the default setting is mm).
Press
[OK]
. A blinking question mark (?) appears.
Select mm or inch using
or
.
Press
[OK]
.
Set the dimensions of the paper as described in the next section.
Entering the Width and Length
Enter the paper size for X Dimension and Y Dimension as shown in the figure.
When the unit of measurement is set, press
.
>>X Dimension appears (the paper width setting).
Press
[OK]
. A blinking cursor (_) appears.
Press
or
to increase or decrease the value of the figure where the cursor
is blinking and display the desired width. The width can be set between 148
and 216 mm (5.83 to 8.5 inches). You can use
ou
to move the cursor
right and left.
Display the paper width and press
[OK]
.
When the width is set, press. >>Y Dimension appears (the paper length
setting). Set the desired length in the same way as the width. The length can
be set between 210 and 356 mm (8.27 to 14.02 inches).
Display the paper length, press
[OK]
.
Press
[MENU]
. The display returns to Ready.
To print using the custom size set above, define the same custom size on the
printer driver.
X Dimension
Y Dimension
148 to 216mm
(5.83 to 8.5 inches)
210 to 356mm
(8.27 to 14.02 inch
es)
LU 252 745 005 Fonctions d'impression HFF GB.book Page 55 Mercredi, 7. juin 2006 4:56 16
