7
Assembly
WARNING
•
Remove batteries before removing barrel.
•
Never operate unit when barrel is removed.
•
Keep fan away from face and avoid contact
with fingers.
1. Align the two lugs on the rear face of the
barrel with the two recesses on the inner
edge of the front face of the housing and
push together, rotating clockwise until
small click and the large hole in the barrel
is pointing directly upwards.
2. Ensure that a mesh filter is in the burn
chamber. If no mesh filter is present, insert
a mesh screen into the top of the burn
chamber and press down with a finger to
seat into the bottom of the burn chamber.
3. Ensure the spring is seated in the groove
on the outer cylindrical face of the burn
chamber.
4. Assemble the burn chamber into the open
recess in the top of the barrel on the main
unit. Push down until the spring provides
a small click or the burn chamber is seated
low in the barrel with no gaps around the
perimeter.
CLICK
5. Retrieve the silicone hose with 2 rigid
fittings, insert the connection nozzle into
the circular hole in the front face and press
firmly to secure the hose.
BATTERIES
Use 4 x AA (1.5V alkaline) batteries only.
(No rechargeable batteries)
1. Remove battery cover from underside
of unit by sliding clip towards rear and
rotating outwards.
2. Insert batteries into cavity with orientation
to match the outer face of the battery cover.
3. Replace battery cover and press to
snap into place.
