Sage Fast Slow GO BPR680, Быстрое руководство

Страница: 22 / 28

22
DELAY START
The Fast Slow GO™ has a timer function to
delay the start of cooking for up to 24 hours.
This timer function does not apply to the keep
warm and steam functions.
The DELAY START function is disabled for
MEAT food preset.
CAUTION
Never allow meat, poultry, seafood, eggs
or other goods that require refrigeration to
sit at room temperature for more than two
hours. Bacteria quickly multiplies in warm
temperatures between 4°C and 60°C.
The following steps show how to program
for delayed cooking:
• Adjust cooking cycle time and temperature/
pressure level as desired.
• Press ‘DELAY START’ button to enable
DELAY START function.
• The screen will show the delay start time
in hours and minutes.
• Use the TIME (+/-) buttons to adjust the
time delay in 15-minute intervals for up to
24 hours.
• Press DELAY START again at any time to
exit without saving the delay start setting.
• Press START/CANCEL to activate the
current cooking settings with a delayed
starting time.
• Time will start counting down and preheat
LED will not be illuminated during DELAY
START.
ALTITUDE ADJUST
Pressure builds and increases when the
temperature inside the cooking bowl exceeds
boiling point. As altitude increases, the
temperature at which water boils decreases
as a result of the drop in air pressure. This
creates very different conditions for cooking
when using a pressure cooker.
In order to maintain consistent cooking results
at various altitudes, the Fast Slow GO™ has
an Altitude Adjust feature that adjusts the
settings based on the altitude of your current
location.
1. To enter Altitude press and hold both
the DELAY START and KEEP WARM
buttons for 2 seconds.
2. Press the TIME (+/-) buttons or the
PRESSURE/TEMPERATURE (+/-)
buttons to adjust altitude.
3. Four-digit display shows ‘Alt’ and number,
switching every 1 second.
4. Press START button to confirm and
a beep will sound.
5. The cooker’s settings have now been
adjusted for your current altitude. Pressing
any button or quitting after timeout
will save the current set altitude value.
To change altitude to factory settings,
adjust the altitude back to 0 metre.
NOTE
Exact altitude can be found at
www.elevationmap.net or by contacting
Sage Customer Service Centre.
SETTING THE UNIT MEASURE
The unit measure default is in Celsius (C).
To change between metric and imperial units,
press the PRESSURE/TEMPERATURE
(+/-) buttons for 5 seconds and the display
will show F for Fahrenheit. Press the
PRESSURE/TEMPERATURE (+/-) buttons
again for 5 seconds to revert to Celsius and
the display will show C.