Phenomenon
Cause
Solution
The starting and end points
do not match.
The specified length is not
plotted or cut.
(slight distance error)
The cut corners are rounded
or too pointed.
The cut line starts
out crooked.
The blade skips and does
not completely cut lines
1.check your data
2.The offset is too low
3.The medium is too flimsy.
4.Knife holder rotation
insensitive
Adjust the OFFSET value.
• If it is too low, the corners
become rounded.
• If it is too high, the corners
are too pointed.
1.Knife holder rotation
insensitive
2.The force is too low
3.Replace the cutter blade
with a new one
4.Grease the cutter blade
and holder.
1.Lower the SPEED setting.
2.Adjust the blade length.
Specify the appropriate
distance correction value.
Cutting deviation from
normal cut line
Corrected offset value again
The Cutting
Results are
Unsatisfactory
5.2Cutting effect problem
