the Stand (and repeated at the end of this manual). The Stand will correctly support the Tool under normal
operating conditions.
WARNING: A free-standing saw must be located away from areas where it could be
accidentally tipped over.
Mounting the Motor on the Carriage (Saws)
Models C-4, H-4, H-5, H-6
The saw motor is inside the box marked “Saw Motor”. It is shipped with two washers, three nuts, and one bolt
installed. Remove these items to mount the saw to the turntable on the carriage.
Figure 5: Mounting the Saw Motor (Models C-4, H-4, H-5, H-6,)
1. Loosen the carriage rip lock and lower the carriage to a comfortable working height. Then tighten the
carriage rip lock securely.
2. Mount the motor to the carriage by inserting the studs (6) on the saw motor through the holes in the turntable
(5). See Figure 5. Install the washers and nuts (7), and hand-tighten only.
3. The bracket (8) that extends from the saw handle has a single hole. Place the spacer (9) between the
bracket on the base and the bracket on the saw handle. Align that hole with the hole in the turntable as
shown in Figure 5, and insert the bolt (10). Install the nut, and hand-tighten only.
4. Make sure the screw (11) on the saw motor plate is flush against the turntable bracket as shown, to ensure
the saw is square. This screw (11) is factory-set and does not require adjustment when the tool is being
installed.
5. Tighten
the
two bottom nuts first (7)
, and the top nut (10) last.
Models 6400, 6800
The Models 6400 and 6800 are shipped with the saw motor already mounted.
Models 7400, 7400XL
The Models 7400 and 7400XL are shipped with the saw motor already mounted.
11
