XXXXX
22
WARNINGS:
Do not use child restraint without the
seat pad. Failure to do this can result in serious injury or
death.
Cleaning Pad and Accessories
Machine wash all pieces separately with cold water on a gentle cycle.
Make sure harness covers are closed so fastening strips are not
exposed. Do not use bleach. Tumble dry separately for 10-12 minutes
on low heat. Remove immediately.
Cleaning Harness Strap
Spot clean using warm sudsy water and damp cloth.
Replacing Pad
Adjust the headrest to the highest position. Starting from the bottom,
gently pull headrest pad onto headrest. Slide harness straps into slots
in pad. Slide the fabric headrest tabs in slots on back of headrest and
between the headrest and headrest foam by the headrest/harness
adjustment handle.
Starting from bottom of child restraint, slip pad on shell. Pull harness
adjustment strap through pad. Wrap pad around bottom and sides
of shell. Push harness holders through slots in pad. Push pad behind
headrest. Wrap around the top of shell. Attach fasteners.
9.
From the Top, Pull Pad
Off of Shell
Installing Harness System
2.
Insert Buckle’s Metal
Retainer into Slot
Closest to Child
Buckle
MUST
face out. You
MUST
use the 1st or 2nd buckle slots
when child restraint is used rear
facing. Any slot can be used when
forward facing.
1.
Fully Recline the Child
Restraint
Pull out on recline handle and push
top of child restraint back.
4.
Check Buckle
Pull up on buckle to make sure it
is secured. The buckle
MUST
not
pull out.
3.
Reach Under Seat
Between Base and Shell
and Through Recline
Handle
Pull metal retainer completely
through pad and shell.
1
2
3
21
continued on next page
4358-6835 Grow and Go Air.indd 27-28
4358-6835 Grow and Go Air.indd 27-28
10/29/15 3:33 PM
10/29/15 3:33 PM
