Safety 1st CCA 2010 A, Руководство пользователя

Страница: 6 / 24

ANCHORAGE FITTING INSTALLATION
Read and follow all of the installation instructions for maximum protection. If you
have any questions regarding the installation or use of this restraint, please contact
Dorel Australia or a child restraint fitting station authorised by the relevant State
Government body or in New Zealand, to consult the agent for the vehicle.
This restraint must be used with an adult lap or lap-sash seat belt. Do not modify
or alter this restraint in any way. Use only Dorel Australia recommended parts and
accessories.
Protect all webbing from possible damage by sharp edges and corners.
Check your vehicle owner’s handbook for the location of correct anchorage
points and the possible need for spacers. If a suitable anchorage point cannot
be found, contact a child restraint fitting station for recommendations about
your vehicle.
Some vehicles may have anchor points which are recessed below the vehicle
trim, spacers are supplied to raise the anchor point if required.
Extension straps and extra fittings are available from various stores.
5
Using the seat belt locking clip to convert a lap-sash belt to a lap only belt.
NOTE:
Locking clip can be fitted on either side depending on the vehicle
seatbelt and child restraint configuration.
1. Using a locking clip (Fig A) to convert a lap-sash belt to a lap only belt.
2. Hold the lap and sash straps (Fig B) together. Thread webbing (still pinched)
into the locking clip, one side at a time (Fig C & D)
3. Repeat step 2 for the other slot in the locking cip. (Fig E & F )
4. Feed the straps through the locking clip to remove any slack.
5. If the locking clip is on correctly, it will hold the lap belt securely, if the lap
belt slips repeat the previous steps.
6. Locking clips are available from most speciality outlets or from
Dorel Australia Customer Service (1300 809 526)
INSTALLING LOCKING CLIP ( OPTIONAL )
A B C
D
E F
Fig 4.
WARNING