Your vehicle’s features may be considerably different
than those pictured here.
When anchors are available, you
MUST always
attach, adjust, and
secure the tether (top anchorage) strap
when installing the car
seat. Tethers improve the installation and stability of car seats and
reduce the risk of injury. Attach the tether hook to the tether anchor
designated by your vehicle manufacturer for that seating position.
Check your vehicle owner’s manual for more information. If the seating
position does not have a tether anchor, use a different seating position
or see your dealer or a qualified mechanic and have one installed.
Top Tether
Child Restraint Use
51
52
NEVER
take your child out of the child restraint while
the vehicle is moving.
NEVER
leave your child unattended. Placing your
child in a hot child restraint may result in burns.
DO NOT
use a child restraint with damaged or
missing parts.
DO NOT
use a child restraint with cut, frayed, or
damaged harnesses.
DO NOT
substitute parts or try to modify the child
restraint in any way.
DO NOT
lubricate buckles and
fasteners.
DO NOT
use any child restraint accessory except
those approved by Dorel Juvenile Group.
NEVER
allow any child to play with this child restraint;
it is not a toy.
DO NOT
remove or cover up any of the warning labels
or other labels on the child restraint.
This child restraint has been certified for use in
passenger vehicles.
DO NOT
use in a boat, on a
motorcycle or in a cargo van or bus where there are
no seat belts or tether anchors.
Read all instructions for additional warnings.
Using this child restraint without the tether strap anchored as
required by the manufacturer would be a misuse of the child
restraint and, in a sudden stop or crash, could result in serious
injury or death.
DO NOT
fasten multiple tether hooks on the same tether anchor in
the vehicle.
WARNING:
WARNING:
Storing Top Tether Strap
The tether strap
MUST
be properly stored in
its storage location when:
• using the
Booster Seat Mode
;
OR
• the car seat is not installed in a vehicle.
Attach the tether hook to its storage location
as shown. Gently tighten to remove slack.