34
Forwar
d-Facing Use:
22-40 lbs.
(10.1-18 kg),
34-43” (85.1-110 cm),
Ov
er 1 y
ear of age
.
With weakest hand at the
belt path, tilt and push the
child restraint from side
to side. If the LATCH
belts do not loosen, your
child restraint should be
secure.
NOTE:
Some “play” from
front to back or about an
inch from side to side is
acceptable. If it moves
more, review “Knowing
Your Vehicle Belts” and
“The Locking Clip”
sections.
4
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it can result in
serious injury or death.
After checking for hot
seat and buckles, place
your child in the child
restraint as described in
the “Securing Your Child in
the Child Restraint”
section.
5
Forward-Facing Installation with
LATCH Belt: Install LATCH Belts
1
NOTE:
Do not use
LATCH system along
with the adult lap or
lap/shoulder belt.
Route LATCH belt
through upper slot in side
of shell.
2
Pull one LATCH hook
across the back and out
the other side.
The LATCH adjuster can
be on either side, but the
belt should not be
twisted.
Connect and tighten
harness straps prior to
installing in vehicle.
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush against
the back of the vehicle
seat back, if needed.
NOTE:
Locking clip is
shown installed.
3
continued on next page.
35
4358-3340D Elite_Lux 3/13/06 3:08 PM Page 37
