PINBRAZING
- Connect the brazing gun, power and trigger cable to the unit.
- Connect the ground device to the unit.
- Press on/off button and select the right pin type by pressing the ”setting” button.
The unit will remember what setting was used last.
- Load the gun with brazing pin and ferrule.
- Make sure to braze in the top of the hole when
brazing to a vertical surface.
Operation.
- Hold the gun fi rmly with both hands as shown
and pull the trigger just once.
The electronic will by itself fi nish the brazing
process.
- Hold the gun in place for 3-4 sec after the
brazing while the braze freezes.
- Remove the gun
straight
backwards
without pulling the trigger!
- Knock off the shank of the brazing pin.
The brazing is completed.
If the brazing is aborted to early
“ERROR”
will turn on.
The brazing should be redone for a good result.
The lamp will be shut down after 8 seconds.
NOTICE!
The battery indicator “LOW BATT” fl ashes when the batteries are almost discharged,
when the “LOW BATT” is constantly lit the batteries are discharged and you can’t do
any more pin brazing. Charge the battery.
7
