19
6)
Dialling Times: 5
7)
Siren Duration: 30 minutes
8)
Leaving Time: 5 seconds
9)
Entry Time: 0 second
10)
Ringing Times Set via Remote Control: 9 times
11)
Defense Zone Attribute: Full Arm
3.
Detailed Programming Operation of Alarm Host
All programming operations below shall be performed in set-up mode.
The Procedure for Entering into Set-up Mode:
Step 1:
Enter “# # #” through the keyboard panel of the host
— —
Users can hear a voice prompt “Please enter the preset password”, and the
“
SET
”
indicator lights up.
Step 2:
Enter A A A A A A # through the keyboard panel of the host
——
The format of user password is AAAAAA, and the factory default password is
“112233”. If user password is correct, users can hear a voice prompt “The
alarm host is entering into adjustment mode”. And then users can continue with
the next step. If user password is wrong, the system will exit set-up mode, and
at the same time, the set-up indicator goes out.
Note:
Note:
Note:
Note:
As mentioned above, the following programming operations shall be
performed after the host enters into set-up mode. If any error occurs during set-up,
enter 0# (the system gives out a voice prompt “Back”) to the previous step. Once
set-up is completed, enter 0 # 0 # to exit set-up mode (the system gives out voice
prompt “Back-Exit Set-up”).
1) Select Alarm Mode
①
Command Function: Telephone Alarm Mode
Command Grammar: 1 #
Function Description: This command enables the host to work under
telephone alarm mode and to cancel all alarm information displayed on the host.
Operating Steps: “###”
（
Please enter the preset password
）
+ “112233#”
（
The
host enters into adjusting mode
）
+“1#”
（
The host is fully armed,
and telephone alarm mode is activated
）
.
