11
10
Color label
5. PERSONALIZING THE STOVE GUARD
6. TROUBLESHOOTING
Press the OK button
❸
to find out the problem type by the indicator light
❹
:
Indicator light
❹
blinks in blue:
Indicator light
❹
blinks in yellow:
• Blinks once: Problem with wireless
connection.
• Blinks twice: Problem with power control
unit
Ⓒ
.
• Blinks three times: Power control unit
Ⓒ
over-heating.
• Blinks once: Probem with sensors
❻
.
• Blinks twice: Problem with sensor unit
Ⓐ
• Blinks three times: Faulty installation
position of the sensor unit
Ⓐ
: see remedy
on the table below.
Problem
Remedy
Cooker cannot be
switched on.
See chapters 3.2 or 3.3. If the problem persists, press the OK
button
❸
to find out the problem type, see the table above.
Faulty installation
position of the sensor
unit
Ⓐ
.
Sensor unit
Ⓐ
will automatically recognize its’ installation
position during the first time the cooker is used for cooking.
After the auto-recognition is completed, the stove guard will
prevent the use of cooker and oven if the sensor unit
Ⓐ
is
removed from its’ original installation position. To enable use
of the cooker, place the sensor unit
Ⓐ
back to the mounting
bracket
Ⓑ
.
If the problem persists, the auto-recognition might not have
been successful. Ensure the correct position of the sensor unit
Ⓐ
(see installation manual step 2/2) and manually reconnect
the wireless connection according the installation manual
chapter 5.2. The fault should be then reseted automatically in
two minutes.
The appliance repeatedly
gives false (the indicator
light
❹
is blinking red
and cooker power is
switched off).
Test the working order according to chapter 4. Maintenance. If the
appliance is in working order, but the Stove Guard gives repeatedly
false alarms, you may adjust the alarm limit of the appliance. See
installation manual.
The appliance repeatedly
gives false alarms,
especially when the oven
is in use.
There may have been a mistake in the calibration of the appliance.
See installation manual.
The appliance repeatedly
gives out water leakage
alarms.
For instructions, see chapter 3.5. If the alarms recur, take off the
fuses for the cooker and the oven. Check that the leakage sensors
are correctly connected. Put back the fuses.
Please contact your vendor support if you cannot solve your problem with these instruc-
tions.
Front cover
ѧ
HINT
You may print your own color label and
place it in to the stove guard to match the
stove guard perfectly into your kitchen
wall.
You may change the color of the stove
guard with the provided color labels. The
stove guard is delivered with 10 different
color labels and one transparent front cov-
er and one opaque white front cover.
1. Remove the sensor unit
Ⓐ
from the
mounting bracket
Ⓑ
by pulling it gently.
2. Remove the front cover from the
sensor unit
Ⓐ
by lifting it from the back
of the sensor unit.
3. Place desired color label on top of the
sensor unit. Make sure that none of the
sensors are masked with the label.
4. Place the transparent front cover on
the sensor unit and place the sensor
unit
Ⓐ
back onto the mounting bracket
Ⓑ
.
