19
FD1600 v.2.03 EN
Startup
Boot menu
Holding down one of the menu buttons while power is connected
displays a “boot menu”. The specific boot menu or function is
selected when button is released. If button was pressed by mistake,
release the button while unit show “RDY”, or keep pressing the button
until display continues to normal working state (8-10 seconds).
“RDY”
The unit is ready and no changes are made. In lower line the current
firmware version is shown.
“CFG”
Configuration is loaded from SD card, this can be used to copy a
configuration from one unit to another.
“BTL”
Bootloader is activated.
“CLR ALL”
All parameters are cleared to factory defaults.
Arrival
Both arrival trigger and arrival sound is programmable. The arrival
sound is heard on floor displays and SYS unit if used. No arrival
sound on CAR units.
Trigger
It is possible to make arrival trigger on a number of events, but not
all combinations make sense. As an example “CAR reduce” only
make sense when using either external position device (IPS) or an
encoder. “External input” only make sense if we also define and use
an external input.
Sound
Some basic sounds are available if no SD card with sounds is used.
If more sophisticated sounds are required, an SD card with sounds
must be installed, and the sound setup must be performed by an
external programming tool (computer or smartphone application).
If only one of the menu buttons is pressed, the menu for volume
is entered directly. The volume can then be adjusted up or down
as desired. If both buttons are pressed, the main menu is entered.
When both buttons are pressed and a menu is already selected,
the next submenu is shown. When end is reached (no more
submenus), the main menu is shown again. If both buttons are
pressed for 2 seconds in a submenu, the main menu is shown.
Menu buttons
“UP” = increase item / value / menu
“DOWN” = decrease item / value / menu
“ENTER” = both buttons pressed = accept value or enter menu/sub-menu
“CANCEL”= both buttons pressed for 2 seconds
Setup menu
