PRIME DESIGN, A SAFE FLEET BRAND
▪
Address: 1689 Oakdale Avenue #102, West St Paul, Minnesota 55118
▪
Phone: 651-552-8554
▪
Toll Free: 1.8.PRIME.RACK
▪
Fax: 651-552-1799
▪
Email: [email protected]
▪
Website: www.primedesign.net
TM & © 2019 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6764268, 6971563, 2364879, 8857689, 8511525, 8991889, 2271515, 2364897, 9506292, 9481313, 9481314, 9796340, 6202807, 6427889, 9415726 AND OTHER PATENTS PENDING
13
HRI3-E-FT33B
ASSEMBL
Y INSTR
UCTIONS–LEFT SIDE RO
TA
TION
19.6
Assemble the L Post
hardware. Do not
tighten until Step 19.8
Note:
The orientation of
the bolt hole faces away
from the Crossbar
Slide L Post Bracket Clamp into
bottom groove, then slide into
L Post Connector as shown
19.4
Bracket Clamp sits
in L Post Connector
Clamp as shown
19.5
Ensure the Auto Clamp Spring
is seated into the spring catch
19.3
L Post seats into the
Crossbar’s inside bottom
groove as seen from the
rear of the Front Crossbar
19.2
Place an L Post into the bottom
groove of the Front Crossbar
L POSTS
SEE QUICK START GUIDE FOR ADJUSTMENTS
NOTE:
The front Auto Clamp come preset from the factory
for packaging purposes only. To assemble the L Post to the
Crossbar, the Auto Clamps must be repositioned.
Beginning with the Front
Crossbar, loosen the bolt at the
bottom of the Auto Clamp, then
slide the Auto Clamp toward the inside
end of the Rotation Upper. Reposition
the Auto Clamp leaving a minimum
of 1/4” distance from the rubber
bumper to the edge of the Auto Clamp
Bracket as shown, then finger-tighten if
adjusting later, or torque to 80 in-lbs.
19.1
Содержание Prime Design HRI3-E-FT33B
Страница 1: ......
Страница 16: ...USAM HRI3EFT33B US01 Rev D 0419 ...
