Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
4
Even
Even
Even
Even
Same as Front
Fig. A
Center
(if equipped)
Rear
Front
Vehicle
Rear
Vehicle
Front
7.50”
FBM-1009
ASSEMBL
Y INSTR
UCTIONS–ERGORA
CK MOUNTING
2E.2
Torque all of these Crossbar
Clamp nuts to 90 in-lbs as
referenced in Figure A
CROSSBAR ADJUSTMENT
2E.3
Verify the specified
distance from the
ends of both Mounting
Bracket to the ends of
both Channels.
2E.4
2E.4
Torque only the Rear Crossbar Mounting
Bracket bolts to 90 in-lbs at this time.
The Center (if equipped) and Front
Crossbar Mounting Brackets will
be torqued to specification when
designated in the respective Feature
(FEA) Assembly Manual.
2E.1
CROSSBARS (ERGORACK)
Shown with LH Base, and
RH Rotation for illustrative
purposes only
Do not mount the Crossbars to this FBM system at this time.
Refer to the respective FEA or AR Assembly Manual(s)
included with your chosen rack configuration features.
Depending upon the features chosen, you may need to
perform a complete feature assembly onto the Crossbars or
Side Rails as noted in that feature’s Assembly Manual.
WARNING: Failure to position the Crossbars as shown in this
FBM Assembly Manual may result in damage to the sliding
door and/or ladder rack.
NOTE:
Crossbars, Side Rails, Base, Clamp Down, or Rotation
features are not included in this FBM kit, and must be
purchased separately. To purchase applicable features and
accessories, please contact your authorized distributor, or a
Prime Design Sales & Service Representative.
