Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
4
Even
Even
1.00”
Figure 2
Figure 1
M8 x 30MM
2
If mounted to a Rotation/Rotation rack, center the Accessory
Light Holder evenly between the Uppers as seen in Figure 1.
If using on a rack equipped with only one rotation, mount a
minimum distance of 1.00” to prevent interference or binding
with the Rotation Upper as seen on Figure 2. Torque Light
Holder Clamp nuts to 90 in-lbs.
1.5
Attach the GoLight Holder to the Mounting Clamp
using the hardware shown and torque to 90 in-lbs.
1.6
ASH-8033 ASSEMBL
Y
INSTR
UCTIONS
NOTE: Ladder Rack shown is for illustrative
purposes only, and is not included with this
Accessory Light Holder Kit.
This Light Holder Kit contains only the parts
needed to repair, replace, or retrofit one
Crossbar. Order an additional kit for the other
Crossbar to add an additional accessory light.
GEN5 LOW PROFILE LIGHT HOLDER
INSTALLATION SEQUENCE
Not all Gen5 racks will have enough space between
Rotation/Rotation Uppers to fit a Light Holder. Measure
prior to installing to ensure there will be no rotation
Upper interference. A minimum of 10.00” is required
between the inside ends of Rotation/Rotation Uppers.