1850-37: 4 of 4; 06/02
Safco Products Company, New Hope, MN 55428
Carefully lay the unit on its left side. Using a soft hammer
or mallet, tap the O Hinges into the recesses on the Q
Left Door Panel. Use the pre-installed screws to fasten
the P Hinge Mount Plates into the pre-drilled holes on
the Left Side Panel. If the Hinge and Mount came in
separate pieces, bend the arms of the Hinges and insert
the slots of the arms over the Hinge Mount Plate set
screws. Adjust door position and tighten the set screws.
Turn the unit onto its right side, and repeat with the R
Right Door Panel.
7
R RIGHT DOOR PANEL
NOT SHOWN
SET
SCREW
TIGHTEN
SET
SCREW
ARM
SLOT
LEFT
SIDE
PANEL
Q
P
O
O
P
SET
SCREW
TIGHTEN
SET
SCREW
ARM
SLOT
With two people, carefully stand the unit upright.
Fasten one S Door Handle to the outer side of
the Left Door Panel using two T Long Screws.
Fasten the other Door Handle to the outer side of
the Right Door Panel with two more Long Screws.
If necessary, center the Door Panels by adjusting
the set screws on the Door Hinges as needed.
8
Lower the D Top Panel down onto the side panels.
Guide the Screw Posts into the holes on the upper
edges of the side panels. Fasten by turning each of
the engaged cams CLOCKWISE until they stop.
Prevent the assembled unit from rolling by activat-
ing the brakes on the Swivel Casters with Brakes.
9
S
S
T
D
Q
R
