9
XL-AS20015BM-en-US Rev E · 2022-10-05 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Installation Instructions
Figure 17
12. Connect each axle T-fitting to the electronic regulator
output in the control box
(Figure 17)
.
13. Secure air lines between axles, air tank, and electronic
regulator control box with 6" cable ties. Securing the air
lines to the brake hoses is recommended.
NOTE:
Wire loom is recommended to protect air line
from sharp corners on the trailer sub-frame.
Protective loom (not shown) should be
used over the air line. Failure to install a
protective loom could result in chaffing
the air line which, if not avoided could
shut down the Tire Pilot Plus system.
14. Locate the ABS power cable and disconnect as illustrated
in
Figure 18
.
15. Install power adapter as illustrated in
Figure 19
. Use
dielectric grease in the connections if not already present.
16. Secure the ABS power adapter using a cable tie as
illustrated in
Figure 20
.
17. Route the wiring harness through the trailer cross rails to
connect the wiring to the electronic regulator control box.
If the electronic regulator is located on a
sliding suspension, be sure to leave
enough wiring loose to route along the
factory coiled wires and hoses at the
stinger bracket.
continued
Figure 18
Figure 20
Figure 19
POWER CABLE
OUTPUT
(TO TIRES)
