Saeco Xelsis SUPREMA & DELUXE, Руководство пользователя

Страница: 23 / 859

20
English
Problem Cause Solution
After a long period of non-use, you need
to prepare the AquaClean water filter for
use again and dispense 2-3 cups of hot
water.
The AquaClean water filter is
clogged. Replace the AquaClean water filter every 3
months. A filter that is older than 3
months can become clogged.
The grinder is set to a too fine
setting. Set the grinder to a coarser (higher)
setting. Note that this will impact the
coffee taste.
The brew group is dirty. Remove the brew group and rinse it under
the tap (see 'Cleaning the brew group
under the tap').
The coffee dispensing spout is
dirty. Clean the coffee dispensing spout and its
holes with a pipe cleaner or needle.
The pre-ground coffee
compartment is clogged Switch off the machine and remove the
brew group. Open the lid of the pre-
ground coffee compartment and insert
the spoon handle into it. Move the handle
up and down until the clogged ground
coffee falls down (Fig. 28).
The machine circuit is blocked by
limescale. Descale the machine with Philips descaler
(see 'Descaling procedure'). Always
descale when the machine prompts you.
The milk does not froth. The internal cappuccinatore is
dirty or not inserted correctly. Clean the internal cappuccinatore and
make sure that you position and insert it
correctly (see 'Cleaning the internal
cappuccinatore under the tap').
The type of milk used is not
suitable for frothing. Different types of milk result in different
amounts of froth and different froth
qualities.
The milk is splashing. The milk you use is not cold
enough. Make sure you use cold milk coming
directly from the fridge.
' The flexible milk tube is not
connected properly. Open the door of the coffee dispensing
spout (Fig. 37) and check if the flexible
milk tube is fully connected to the
cappuccinatore (Fig. 43). Note that the
cappuccinatore and milk tubes may be
hot. Let the cappuccinatore and the tubes
cool down before you touch them.