Saeco TALEA, Руководство по обслуживанию

Страница: 15 / 99

Page 2 / 13 Saeco International Group
03 OPERATING TALEA / ODEA - LINE
Reset: Press the hot water key for 10 seconds
3.1.2 Odea Giro,Talea Giro
“Appliance ready” LED:
•
Permanently on: The appliance is ready for use.
• Flashing: The appliance has to fi nish the heating-up phase.
“Empty dreg drawer” LED:
•
Permanently on: Empty the dreg drawer. The appliance must be switched on for this procedure.
“Descaling” LED:
•
Flashing: Start the descaling cycle.
Alarm LED:
•
Permanently on (one or more causes): No coffee left, water tank is empty, the residual water tray is
full (in this case the dreg drawer also has to be emptied to prevent problems).
• Flashing slowly (one or more causes): Brewing unit is missing, dreg drawer has not been inserted,
coffee container cover has not been inserted, service door is open, rotary knob for opening the hot
water / steam is not in the right position.
• Flashing rapidly: Ventilate the water system.
Coffee dispensing key:
•
Flashing slowly: 1 coffee selected (key pressed once).
• Flashing rapidly: 2 coffees selected (key pressed twice).
“Hot water” key:
•
Off: The appliance dispenses
steam.
• On: The appliance dispenses hot
water.
Ground coffee quantity (Opti-dose)
key.
Control to set how much coffee is dispensed into the cup.
and LEDs fl ashing alternately: turn off the appliance. Turn the appliance back on after 30 secon-
ds and wait until the movements stop. Then turn the appliance off again. Remove the brewing unit and
clean thoroughly (see page 29). If the display reappears when you turn the machine back on, contact the
Service Centre.