Saeco OTC SERIES, Руководство по обслуживанию

Страница: 42 / 62

INCANTO 05 SERVICE MODE
9/9
When the Steam-Out is complete the following parameters are reset to their default values
Parameters Default value Description
Espresso_pulses_qty 145 Length “Espresso” product
EspressoLungo_pulses_qty 345 Length “Espresso Lungo” product
Classic_Coffee_pulses_qty 500 Length “Classic coffee” product (not used in Incanto
machine)
Cappuccino_pulses_qty 170 Length “Cappuccino” product – Number of flow meter
impulses during coffee cycle
Cappuccino_milk_brew_time 340 Length “Cappuccino” product – Time of milk
brewing (x100ms)
Lattemacchiato_pulses_qty 120 Length “Latte Macchiato” product – Number of flow
meter impulses during coffee cycle
Lattemacchiato_milk_brew_
time
400 Length “Latte Macchiato” product – Time of milk
brewing (x100ms)
FrothMilk_milk_brew_time 340 Length “Froth Milk” product – Time of milk
brewing (x100ms)
Coffee_Grinder 0 Number of grounds in dregs drawer
Alarm_Refill TRUE Request priming circuit next power-on of the machine
Bu_Loaded FALSE Set Brew-unit clean and not fill with coffee
Aroma_Espresso 3 Beans Aroma for high pressure products
Aroma_Drip 4 Beans Aroma for low pressure products (not used in Incan -
to machine)
TimeSleep 15 minutes Timer for enter in stand-by from normal mode
Filter_Present FALSE Presence of Brita filter in machine (not used in Incanto
machine)
FilterPulses 0 Impulses brew through Brita filter (not used in Incanto
Machine)
IMPORTANT NOTE: to execute the Steam-Out procedure the DREGDRAWER
must be in place and the DOOR must be closed.
If these 2 conditions are not respected a warning message is shown on the
display and the Steam-Out is interrupted.
The machine starts the Steam Out and in the display appears the indication
“ON”.
While the Steam Out runs the Electro valve is opened and water comes out
the Water/Steam pipe.
When the Steam Out is complete the message “COMPLETE” is shown on
the Display.The Electro valves automatically closes and the machine can be
switched off.
Once entered the Steam Out mode the display shows the “STEAM OUT” indi-
cation. Buttons can be released.
IMPORTANT NOTE:
to execute the Steam-out procedure the Ntc sensor
must work correctly; if some errors occurs on Ntc during the steam-out, the
procedure can’t continue and an error message is shown on the display.