R e s o l u t i o n
Check plug and fuse
Close the service door
Insert or position the central unit
Disactivate the function and drain the
machine (see page 30)
Fill with water or coffee bean and
switch the machine off and then on
again to start the cycle
Drain thoroughly the machine again.
Empty the coffee grounds container
and insert it properly
Clean the coffee grinder
(see page 36)
Fill with pre-ground coffee
Clear it with the aid of a thin needle
Adjust the grinder to a finer grind, ex.
from 6 to 3
Adjust the grinder to a coarser grind,
ex. from 6 to 7
Place the cup on the heating plate
before dispensing coffee into it
Wait until the temperature warning
light switches on permanently
Try another coffee blend
Carry out descaling of the machine, as
described on page 36
Switch on the machine. Close the
service door. The machine returns au-
tomatically to its starting position.
P r o b l e m
The main switch does not turn
on
The automatic coffee brew-
ing does not start
Water is dispensed instead
of coffee
Steam and/or hot water are
not dispensed
Coffee flows too quickly
Coffee flows too slowly
Coffee is not hot enough
Coffee not creamy
The coffee brewing is re-
duced; the machine takes
longer to heat and the water
capacity is not correct
The central unit cannot be
removed
38
DISPOSAL
39
TROUBLE SHOOTING
Important
A periodic descaling avoids expensive re-
pairs. The machine warranty does not cover
damages occurring as a result of the non-
observance of descaling procedures, improper
use and failure to comply with and follow any
other instructions contained herein.
Maintain the manufacturer's adjustment if the
water hardness degree is not known.
Storage of the machine
Switch off the machine and unplug it if
the machine wil not be used for
long periods of time.
Keep the machine in a dry place, far
from the reach of children.
Should the machine not be used for a long period,
protect it from dust and dirt.
Maintenance
Periodically check the machine and clean it in
accordance to the instructions.
Disposal
Machines which are no longer operational should
immediately be made non serviceable, by cutting
the power cord. Machines should be delivered to
a public disposal centre.
Troubleshooting
In case of failure, fault or suspected
damage following a fall, unplug the
machine immediately.
To fix problems, follow the instructions in the
table below. Otherwise contact an authorised
technician.
Only skilled personnel are authorised to service
and repair the machine.
The user might incure serious injuries should
repairs not be properly carried out.
The manufacturer declines any liability whatso-
ever, should repairs fail to be carried out accord-
ing to the instructions contained in this manual.
Furthermore in these cases, warranty rights cannot
be honored.
Possible cause/causes
The machine is not getting power
The service door is open
The warning light is on: the central unit is
not correctly inserted or incorrectly positioned.
The
steam selection button is on.
Empty tank or coffee bean container warning
lights are on
Temperature warning light is on: following a
steam outflow, the machine has not been
properly drained
Coffee grounds warning light is on: the
container is full or not properly inserted
Bean coffee warning light blinking: the coffee
grinder is jammed
Pre-ground coffee selection button has been
pressed, but the pre-ground container is empty
The steam/hot water spout hole is clogged
Grind is too coarse
Grind is too fine
The cup has not been preheated
The temperature warning light is not yet on
The coffee blend is not suitable, coffee has not
been recently ground, the pre-ground coffee
has been ground too thin or too coarse
Limescale in the machine
The central unit is out of position
